Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2013XC60 AWD L6-3.2L VIN 95 B6324S5REPAIR AND DIAGNOSISBODY AND FRAMEFRAMESUBFRAMEREAR SUBFRAMESERVICE AND REPAIR
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5
Rear Subframe: Service and Repair
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Service and Repair
Operation number: 65263-2
Rear subframe
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal
Note! Removal steps in this procedure may contain installation details.
Lower the rear end. Refer to: Rear suspension, service position, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S4, TF-80SC AWD Service and Repair
Vehicles with carbon filter canister
Torque: M6, 10 Nm
Applies to all vehicles.
Remove the drive shafts. Refer to: Rear drive axle, B6304T4, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S4, TF-80SC AWD Rear Drive Axle
Torque: M12, 80 Nm
Vehicles equipped with mechanical parking brake
Torque: M8, 24 Nm
Applies to all vehicles.
Remove the following items:
1. Torque: Upper arm rear to subframe, 110 Nm
2. Torque: Tie rod to subframe, 110 Nm
3. Torque: Lower arm rear to subframe, 90 Nm
Installation
To install, reverse the removal procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.