Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2013XC60 AWD L6-3.2L VIN 95 B6324S5REPAIR AND DIAGNOSISBODY AND FRAMEFRAMECROSS-MEMBERFRONT CROSS-MEMBERSERVICE AND REPAIR
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5
Front Cross-Member: Service and Repair
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Service and Repair
Operation number: 86325-2
Collision member
Removal
Note! Removal steps in this procedure may contain installation details.
Remove casing bumper front Refer to: Cover bumper front, B6304T4, B6324S5, B6324S4 Service and Repair
Remove the following items:
1. Torque: Collision member for subframe upper, 100 Nm
2. Torque: Collision member for subframe lower, 100 Nm
Installation
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.