Diagnostic Functions

Diagnostic functions

General
The control module has a built-in diagnostic system, Volvo Diagnostic, which continuously monitors internal functions as well as input and output signals.

Diagnostic trouble codes (DTCs)
If the control module detect a fault, a diagnostic trouble code (DTC) is stored. A fault that was detected during the last operating cycle is defined as permanent. Other faults that are detected are defined as intermittent.
If for some reason a fault disappears after being stored in the control module as a diagnostic trouble code, the information remains stored in the control module. If a fault is no longer permanent, the status of the diagnostic trouble code is changed to intermittent.

Reading and erasing diagnostic trouble codes (DTCs)
Stored diagnostic trouble codes (DTCs) can be read off and erased using this function.
Diagnostic trouble codes can only be erased once all the diagnostic trouble codes have been read out at least once.

Note! Certain functions are unavailable until diagnostic trouble codes (DTCs) have been erased.

Reading off the parameters
This function is used to read the status or value of parameters. The status or value can be presented digitally.

Activating components and functions
This function can be used to activate components and functions that affect the integrated Audio Module (IAM).

Reading off the control module identification
The diagnostic tool identifies control modules by reading off a number of codes from the control module memory.
The codes contain information about the control module:
- hardware P/N (control module without software)
- hardware serial number (control module without software)
- software P/N
- diagnostic software P/N

Reading off extended fault-tracing information
This function can be used to read out parameters, identify status and counts stored at the same time as a diagnostic trouble code (known as frozen values).