Design

2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Design





Design

Control module




Integrated Audio Module (IAM) is installed in the centre console.
The infotainment control module (ICM) display shows the current status of the integrated audio module (IAM).
The Integrated Audio Module (IAM) has an integrated amplifier (Performance) with an output of 4x20 W.
For versions that do not have an integrated amplifier, the Audio module (AUD) is used as an amplifier.

Remote control




Remote control via the steering wheel keypad is available as either an option or standard depending on the market. The keypad is on the right side of the steering wheel and is connected to steering wheel switch right (SWSR).

Loudspeakers




The integrated audio module (IAM) for Performance has six speakers directly connected to the control module:
In each front door there are two speakers. The 2-way system consists of broad-banded bass/mid-range speakers and separate treble speakers. In both rear doors there is a broad-banded bass/mid-range speaker.
The impedance is 2 ohms for the base/mid range loudspeakers and 5 ohms for the treble speakers.
For versions without an amplifier, the loudspeakers are connected to the Audio module (AUD).
For more information, see Design and Function - Audio Module (AUD).

Microphone




The microphone is directly connected to the Integrated Audio Module (IAM). The microphone transmits analog signals to the Integrated Audio Module (IAM). The microphone has phantom-feed via Integrated Audio Module (IAM).
Telephone calls can be connected via the handsfree. The microphone and speaker are used for calls via the handsfree.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.