Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2011S60 T6 AWD L6-3.0L TURBO VIN 90 B6304T4REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESVEHICLE COMMUNICATION INFORMATION, TRANSMISSION CONTROL MODULE (TCM)DESCRIPTION OF ACTIVATIONS
2011 Volvo S60 T6 AWD L6-3.0L Turbo VIN 90 B6304T4
Description Of Activations
2011 Volvo S60 T6 AWD L6-3.0L Turbo VIN 90 B6304T4SECTION Description Of Activations
Description of activations
Activation of components
With this feature a number of components can be activated for checking its function. Components that can be activated are as follows.
Note! The noise level from the solenoids can be high, depending on the temperature of the transmission and the oil. When the transmission is warm or very cold, the noise level can be very low.
Gear shift solenoid S1, S2
Activation of shift solenoid S1, S2
"Click sound" in the transmission (use stethoscope) and status shall switch between OFF/ON.
System pressure solenoid SLT, SLU, SLB1, SLC1, SLC2, SLC3
Activation of Linear pressure solenoid.
"Click sound" in the transmission (use stethoscope) and the current shall vary between 0 and approximately950 mA.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.