Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2010XC90 FWD L6-3.2L VIN 96 B6324S2REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIR
2010 Volvo XC90 FWD L6-3.2L VIN 96 B6324S2
Seat Temperature Control Module: Service and Repair
2010 Volvo XC90 FWD L6-3.2L VIN 96 B6324S2SECTION Service and Repair
Seat heating module (SHM), replacing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.
Preparatory work
Ignition off
Move the seat to its uppermost position.
Ignition off.
Removal
Removing the seat heating module (SHM)
Remove:
- the 1 clip
- the connectors
- the control module.
Installation
Installing the seat heating module (SHM)
Install:
- the control module
- the connectors
- the 1 clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.