Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLVO2005V70 L5-2.4L TURBO VIN 54 B5244T5REPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT CONTROL MODULESERVICE AND REPAIR

2005 Volvo V70 L5-2.4L Turbo VIN 54 B5244T5

Power Seat Control Module: Service and Repair

2005 Volvo V70 L5-2.4L Turbo VIN 54 B5244T5SECTION Service and Repair

Power seat module (PSM), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the power seat module (PSM)
Raise the seat to its highest position.

Lift the seat out of the vehicle. See: Front seat, replacing Front Seat, Replacing.

Remove the key. The key must be removed to ensure that the ignition is not switched on by mistake.
Wait one minute before starting work.
Remove the 2 screws.
Disconnect the connector.
Remove the control module.

Installation

Installing the power seat module (PSM)

Install:
- the control module
- the connector
- the 2 screws. Tighten
- the key
- the front seat. See: Front seat, replacing Front Seat, Replacing.

Finishing

Ordering software
Order applicable software.

Finishing
Check that no diagnostic trouble codes have been stored during the repair.
Test operate the seat. Check all the functions.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.