Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004XC90 AWD L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGINITIALIZATION PROCEDURE
2004 Volvo XC90 AWD L5-2.5L Turbo VIN 59 B5254T2
Initialization Procedure
2004 Volvo XC90 AWD L5-2.5L Turbo VIN 59 B5254T2SECTION Initialization Procedure
ALLDATA Editor's Note: Although this procedure applies to the V70, other models should be similar.
IF INITIALIZATION IS LOST THE AUTO-UP & AUTO-DOWN WILL NOT OPERATE
To initialize the driver's window:
A. Fully lower the window.
B. Close the window holding the button in the auto-up position. Continue to hold the switch in the auto up position for 5 seconds after the window is fully closed.
or
Use VADIS - vehicle communication, window position set up.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.