Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004XC90 AWD L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISBODY AND FRAMEBODY CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDESCRIPTION OF FROZEN VALUESDESCRIPTION OF FROZEN VALUES, REAR ELECTRICAL MODULE
2004 Volvo XC90 AWD L5-2.5L Turbo VIN 59 B5254T2
Description of Frozen Values, Rear Electrical Module
2004 Volvo XC90 AWD L5-2.5L Turbo VIN 59 B5254T2SECTION Description of Frozen Values, Rear Electrical Module
Description of frozen values, rear electrical module
Explanation
Not all the parameters described need to be implemented in the control module. This varies from system to system.
Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored.
Battery voltage, value
Measurement range: 0-12 V.
Normal value when the generator (GEN) is charging: 13.0-14.5 V.
The value is the voltage from the central electronic module (CEM).
Distance, value
Measurement range: 0-1048575 km.
The value indicates the total mileage of the car at the time the diagnostic trouble code (DTC) was stored.
Passenger compartment temperature, value
Measurement range: -60-195 °C.
The combined instrument panel obtains the value via the control area network (CAN).
Outside temperature, value
Measurement range: -128-127.75 °C.
The combined instrument panel obtains the value via the control area network (CAN).
Engine running, status
The status displays whether the engine was running when the diagnostic trouble code (DTC) was stored.
No = the engine was not running
Yes = the engine was running
Time, value
The value displays the time that has passed since the diagnostic trouble code (DTC) was stored.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.