Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2002S80 T6 EXECUTIVE L6-2.9L TURBO VIN 91 B6294TREPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT CONTROL MODULETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCONNECTING THE BREAKOUT BOX, POWER SEAT MODULE (PSM)
2002 Volvo S80 T6 Executive L6-2.9L Turbo VIN 91 B6294T
Connecting the Breakout Box, Power Seat Module (PSM)
2002 Volvo S80 T6 Executive L6-2.9L Turbo VIN 91 B6294TSECTION Connecting the Breakout Box, Power Seat Module (PSM)
Connecting The Breakout Box, Power Seat Module (PSM)
Special tools:
951 1463
951 1428
951 1499
951 1507
Connecting the breakout box
- Ignition off.
- Remove passenger compartment fuse 24 (11C/24) and passenger compartment fuse 4 (11C/4).
- Remove the power seat module (PSM). See Power seat module (PSM), replacing.
- Disconnect the module connectors.
There are two adapters for the power seat:
Connect adapter 951 1463 to control module connector C to take readings from the connector.
Connect adapter 951 1507 to control module connectors A, B, D and E. Connect breakout box 951 1428 and one or two cables 951 1499 to the adapters.
Disconnect the breakout box in reverse order.
For further information about signals and other values, see Signal specification, Power seat module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.