Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLKSWAGEN2013TOUAREG VR6 LUXREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMGENERAL, TECHNICAL DATA (0C8)00 GENERAL, TECHNICAL DATAGENERAL REPAIR INFORMATIONCOMPONENTSTRANSMISSION

2013 Volkswagen Touareg VR6 Lux

General Repair Information: Components: Transmission

2013 Volkswagen Touareg VR6 LuxSECTION Transmission

Make sure that the alignment sleeves between the transfer case and transmission are positioned correctly when installing the transfer case.
Clean the contact surfaces when installing the brackets as well as any waxed components. Contact surfaces must be free of grease and wax.
For the correct bolts and other components. Refer to the Parts Information
When exchanging a transfer case, the gear oil must be filled up to lower edge of filler hole. Refer to TRANSFER CASE, CHECKING TRANSMISSION FLUID LEVEL .
Transfer case capacity. Refer to CODE LETTERS, TRANSMISSION ALLOCATION AND CAPACITIES .
When exchanging a front final drive, the gear oil must be filled up to lower edge of filler hole.
Front final drive capacity. Refer to CODE, TRANSMISSION ALLOCATION, RATIOS AND CAPACITIES .
When exchanging a rear final drive, the gear oil must be filled up to lower edge of filler hole.
Rear final drive capacity. Refer to CODE, TRANSMISSION ALLOCATION, RATIOS AND CAPACITIES .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.