Vehicle Electrical System Control Module - J519-, Output Diagnostic Test Mode

2013 Volkswagen Touareg VR6 LuxSECTION Vehicle Electrical System Control Module - J519-, Output Diagnostic Test Mode

The following components can be checked with vehicle electrical system control module Output DTM:

  • Right Low Beam Headlamp -M31-, for vehicles with gas-discharge lamps Right Hid Headlamp Bulb -L14-
  • Right High Beam Headlamp Bulb -M32-, on vehicles with HID headlamp bulbs Right Headlamp Reflector Adjustment Solenoid -N396-
  • Left Low Beam Headlamp -M29-, for vehicles with gas-discharge lamps Left Hid Headlamp Bulb -L13-
  • Left High Beam Headlamp Bulb -M30-, on vehicles with HID headlamp bulbs Left Headlamp Reflector Adjustment Solenoid -N395-
  • Left Position Lamp Bulb -M1-
  • Right Position Lamp Bulb -M3-
  • Left Front Turn Signal Bulb -M5- and Left Rear Turn Signal Bulb -M6-
  • Right Front Turn Signal Bulb -M7- and Right Rear Turn Signal Bulb -M8-
  • Left Front Fog Lamp Bulb -L22- and Right Front Fog Lamp Bulb -L23-
  • Only in vehicles with gas-discharge lamps Right High Beam Headlamp -M32- and Left High Beam Headlamp -M30-
  • Headlamp Washer Relay -J39- and Headlamp Washer Pump -V11-
  • Emergency Flasher Indicator Lamp -K6-
  • High Tone Horn -H2- and Low Tone Horn -H7-
  • Left Front Footwell Illumination Bulb -L151-, Right Front Footwell Illumination Bulb -L152-, Left Rear Footwell Illumination Bulb -L106- and Right Rear Footwell Illumination Bulb -L107-
  • Windshield And Rear Window Washer Pump -V59-
  • Seat heating release
  • Supply Rain/Light Recognition Sensor -G397-
  • Emergency start signal

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .

-- In the Vehicle Diagnostic Tester, select "guided fault finding".

-- Using the "Go to" button, select the "function/component selection" and the following menu options in sequence:

  • Body
  • Electrical Equipment
  • 01  - OBD-capable systems
  • 09  - Vehicle Electrical System Control Module -J519-
  • 09  - Vehicle electrical system control module functions
  • 09  - Output diagnostic test mode
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.