Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Automatic Temperature Control (EATC) and Dual Automatic Temperature Control (DATC) Module - Diagnostic Methods: Notes
The electronic automatic temperature control (EATC) and dual automatic temperature control (DATC) system must be diagnosed by first retrieving any DTCs, if present.
- An on-demand (hard fault) DTC indicates that the fault is currently present. An on-demand DTC suggests a wiring fault, disconnected connector or component failure.
- A continuous (intermittent) DTC alone (corresponding on-demand DTC is not present) indicates that the fault is an intermittent condition and may not be currently present. A continuous only DTC suggests a poor wiring connection, loose pin or terminal or intermittent component failure.
On-demand (hard fault) or continuous (intermittent fault) DTCs can be retrieved using a scan tool. If using a scan tool, refer to the scan tool operating manual.
On-demand DTCs can also be retrieved by carrying out the EATC AND DATC MODULE ON-DEMAND SELF TEST . To retrieve and/or clear continuous DTCs, carry out the DATC/EATC MODULE - RETRIEVE CONTINUOUS DTCS procedure. Always carry out the EATC AND DATC MODULE ON-DEMAND SELF TEST before retrieving continuous DTCs.
If no DTCs are present, GO to SYMPTOM CHART for the appropriate diagnostic action.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.