Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Digital Signal Processing Module
The digital signal processing module (if equipped) uses the medium speed CAN for communication with the diagnostic tool. The digital signal processing module works with the audio unit allowing the listener expanded signal manipulation and audio control.
Check the medium speed CAN circuits between the digital signal processing module C4326a and the DLC C251. The total resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms, there is an open circuit in the medium speed CAN, damage to the DLC C251, or damage to digital signal processing module C4326a.
For additional digital signal processing module information, refer to ENTERTAINMENT SYSTEM - GENERAL INFORMATION .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.