Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Pc: Data Link Diagnostics Test
- PC1 DATA LINK DIAGNOSTICS TEST
- Key in ON position.
- Carry out the PINPOINT TEST PC: DATA LINK DIAGNOSTICS TEST .
- Is system passed obtained?
- Yes : The test passed. RETURN to the Symptom Chart of the section for the module in question.
- No
: If international standards organization (ISO) 9141 communications network circuit fault; all electronic control units no response/not equipped, GO to PINPOINT TEST L .
If high speed controller area network (CAN) circuit faults; all electronic control units no response/not equipped, GO to PINPOINT TEST M .
If medium speed CAN circuit faults; all electronic control units no response/not equipped, GO to PINPOINT TEST N .
If no response from the diagnostic tool, GO to PINPOINT TEST O .
If the module in question is no response/not equipped, GO to SYMPTOM CHART .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.