SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE R-LINE, 2.0L ENG VIN TREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1328 (MODULE CONFIGURATION SYSTEM)DIAGNOSIS AND TESTINGMODULE CONFIGURATIONINSPECTION AND VERIFICATION
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN T

Inspection and Verification

2013 Volkswagen Beetle R-Line, 2.0L Eng VIN TSECTION Inspection and Verification
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

This article provides step-by-step module configuration procedures. Carry out the PROGRAMMABLE MODULE INSTALLATION (PMI)  procedures when another article directs to carry out configuration or when DTCs from the below list are present:

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC CHART

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module (without Hybrid)
  • Audio Control Module (ACM) (without navigation)
  • HVAC module (without Hybrid)
  • Front Display Interface Module (FDIM)
  • Instrument Cluster (IC)
  • Power Steering Control Module (PSCM)
  • Smart Junction Box (SJB) (without Hybrid)
 CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
B2900 VIN  Mismatch
  • ABS module (without Hybrid)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0602 Powertrain Control Module Programming Error
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605 Internal Control Module Read Only Memory (ROM  ) Error
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1635 Tire/Axle Out of Acceptable Range
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300 Internal Control Module Software Incompatibility
  • Battery Control Module (BCM)
  • HVAC module (without Hybrid)
  • PCM
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300:00 Internal Control Module Software Incompatibility: No Sub Type Information
  • Restraints Control Module (RCM)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300:51 Internal Control Module Software Incompatibility: Not Programmed
  • ABS module (Hybrid)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U201A:51 Control Module Main Calibration Data: Not Programmed
  • ACM  (with navigation)
  • Front Controls Interface Module (FCIM)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050 No Application Present
  • 4X4 control module
  • ABS module (without Hybrid)
  • ACM  (without navigation)
  • BCM 
  • HVAC module (without Hybrid)
  • FDIM 
  • IC 
  • Occupant Classification System Module (OCSM)
  • SJB 
  • Transmission Control Module (TCM)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2051 One or More Calibration Files Missing/Corrupt
  • 4X4 control module
  • ACM  (without navigation)
  • HVAC module (without Hybrid)
  • FDIM 
  • OCSM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • ACM  (with navigation)
  • ABS module (Hybrid)
  • RCM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00 Initial Configuration Not Complete: No Sub Type Information
  • Accessory Protocol Interface Module (APIM)
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .
U2100:56 Initial Configuration Not Complete: Invalid/Incompatible Configuration
  • ABS module (Hybrid)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information
  • ACM  (with navigation)
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2101:00 Control Module Configuration Incompatible: No Sub Type Information
  • APIM 
 CARRY OUT APIM  programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING .
U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information
  • RCM 
 INSTALL a new RCM  . REFER to RESTRAINTS CONTROL MODULE (RCM) . CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U3000:46 Control Module: Calibration/Parameter Memory Failure
  • RCM 
 INSTALL a new RCM  . REFER to RESTRAINTS CONTROL MODULE (RCM) . CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U3002:62 Vehicle Identification Number: Signal Compare Failure
  • ABS module (Hybrid)
  • RCM 
 CARRY OUT PMI  . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.