Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE R-LINE, 2.0L ENG VIN TREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 961 (MODULE CONFIGURATION SYSTEM)DIAGNOSTIC TESTSMODULE CONFIGURATIONINSPECTION AND VERIFICATION
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN T
Inspection and Verification
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN TSECTION Inspection and Verification
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
This section provides step-by-step module configuration procedures. Carry out the PMI procedures in this article when another workshop manual section directs to carry out configuration or when DTCs from the below list are present:
DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| B2900 | VIN Mismatch |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P0602 | Powertrain Control Module Programming Error |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P0605 | Internal Control Module Read Only Memory (ROM) Error |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P1635 | Tire/Axle Out of Acceptable Range |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| U0300 | Internal Control Module Software Incompatibility |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
| U2050 | No Application Present |
|
CARRY OUT PMI. REFER to Programmable Module Installation . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.