SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE R-LINE, 2.0L ENG VIN TREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 640 (MODULE COMMUNICATIONS NETWORK)DESCRIPTION AND OPERATIONCOMMUNICATIONS NETWORKCLIMATE CONTROL ASSEMBLY
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN T

Climate Control Assembly

2013 Volkswagen Beetle R-Line, 2.0L Eng VIN TSECTION Climate Control Assembly
WARNING: This page is about a different car, the 2006 Mercury Milan, 2006 Lincoln Zephyr, and 2006 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Both the dual automatic temperature control (DATC) module and the electronic automatic temperature control (EATC) module are referred to as the climate control assembly. The climate control assembly uses the medium speed CAN for communication with the diagnostic tool and other modules on the medium speed CAN. The climate control assembly controls the automatic climate functions that maintain the vehicle interior temperature at a constant setting.

Check the medium speed CAN circuits between the DATC module C2356a or EATC module C228a and the DLC C251. The total resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms, there is an open circuit in the medium speed CAN, damage to the DLC C251, or damage to the climate control assembly connector.

For additional climate control assembly information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION AND DIAGNOSTICS .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.