Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE R-LINE, 2.0L ENG VIN TREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 554 (MODULE CONFIGURATION SYSTEM)GENERAL PROCEDURESPROGRAMMABLE MODULE INSTALLATIONUSING THE WORLDWIDE DIAGNOSTIC SYSTEM (WDS) WHEN THE ORIGINAL MODULE IS NOT AVAILABLE
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN T
Using the Worldwide Diagnostic System (WDS) When the Original Module is Not Available
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN TSECTION Using the Worldwide Diagnostic System (WDS) When the Original Module is Not Available
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new module.
- Connect the WDS and ID the vehicle as normal.
- From the Toolbox icon, select and highlight Module Programming. Then highlight the module that was installed and press the check mark.
- Select and highlight Programmable Module Installation. Then highlight the module that was installed and press the check mark.
- Follow the on-screen instructions, turn the ignition key to the RUN position and press the check mark.
- The WDS retrieves the module data, automatically downloads the data into the new module, and displays Module Configuration Complete.
- If the data is not available in the module, the WDS displays a screen stating to contact the As-Built Data Center. Retrieve the data from WWW.FMCDEALER.COM at this time and press the check mark.
- Enter the module data (the module address and line are displayed to the left of the 3 entry boxes) and press the check mark.
- The WDS downloads the data into the new module and displays Operation Successful - Programming Complete.
- Test the module for correct operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.