Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE R-LINE, 2.0L ENG VIN TREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 1400 (COMPONENT TESTING)COMPONENT TESTINGIGNITION SWITCHCOMPONENT TESTING PROCEDURE
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN T
Component testing procedure
2013 Volkswagen Beetle R-Line, 2.0L Eng VIN TSECTION Component testing procedure
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
IGNITION SWITCH - COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | |
|---|---|---|---|
| Run power circuit | 8 and 7 | Lock | Open circuit |
| Accessory | |||
| Run | Closed circuit | ||
| Start | Open circuit | ||
| Run/Start power circuit | 9 and 1 | Lock | Open circuit |
| Accessory | |||
| Run | Closed circuit | ||
| Start | |||
| Run/Acc power circuit | 9 and 5 | Lock | Open circuit |
| Accessory | |||
| Run | Closed circuit | ||
| Start | |||
| Start power circuit | 9 and 10 | Lock | Open circuit |
| Accessory | |||
| Run | |||
| Start | Closed circuit | ||
| Key in ignition | 8 and 3 | Key out of ignition | Open circuit |
| Key in ignition | Closed circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.