Service Interval Display: Notes

2013 Volkswagen Beetle R-Line, 2.0L Eng VIN SSECTION Notes

Introduction of the Maintenance Interval Extension, refer to Introduction of the Maintenance Interval Extension .

Fixed Service Interval Display, refer to Fixed Service Interval Display .

Service when Due through MY 2013, refer to Service When Due Through MY 2013 .

Service when Due from MY 2014, refer to Service When Due From MY 2014 .

Advanced Service Warning through MY 2013, refer to Advanced Service Warning Through MY 2013 .

Advanced Service Warning from MY 2014, refer to Advanced Service Warning from MY 2014 .

Use the Rocker Switch on the Windshield Wiper Lever or the Buttons in the Multifunction Steering Wheel to Check for Service Messages through MY 2013, refer to Use the Rocker Switch on the Windshield Wiper Lever or the Buttons in the Multifunction Steering Wheel to Check for Service Messages through MY 2013 .

Use the Rocker Switch on the Windshield Wiper Lever or the Buttons in the Multifunction Steering Wheel to Check for Service Messages from MY 2014, refer to Use the Rocker Switch on the Windshield Wiper Lever or the Buttons in the Multifunction Steering Wheel to Check for Service Messages from MY 2014 .

Using the Buttons in the Instrument Cluster to Check for Service Messages through MY 2013, refer to Using the Buttons in the Instrument Cluster to Check for Service Messages through MY 2013 .

Using the Buttons in the Instrument Cluster to Check for Service Messages from MY 2014, refer to Using the Buttons in the Instrument Cluster to check for Service Messages from MY 2014 .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.