Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Brake System (ABS) Module
The ABS module controls the foundation brake function as well as anti-lock braking. Any malfunction of the ABS module disables the ABS and the ABS warning indicator illuminates. However, the power-assist braking system still functions normally.
The ABS module is on the high speed CAN. If 1 of the 2 bus wires becomes shorted to ground or voltage, communications on the CAN may not be possible. If there is an open in the network, communications may continue between some modules depending upon the location of the open circuit. Check the high speed CAN circuits 1908 (WH) and 1909 (BK) between the ABS module C1462 and the DLC C251. Total resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms, there is an open circuit in the high speed CAN, damage to the DLC C251, damage to the ABS module C1462, or a problem in the in-line connector. For additional ABS module information, refer to VEHICLE DYNAMIC SYSTEMS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.