Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control System Inputs
HVAC Module
The HVAC module integrates the temperature control, blower motor switch, airflow mode selection, A/C request button, recirculated air request button and rear defog switch into a single unit.
The temperature control switch setting determines air temperature. Movement of the temperature display from COOL (blue) to WARM (red) causes a corresponding movement of the temperature blend door and determines the air discharge temperature that the air distribution system will maintain. The temperature control switch is an integral part of the HVAC module and cannot be installed separately.
The blower motor speed switch is mounted in the HVAC module and controls blower motor speed by adding or bypassing resistors in the blower motor resistor in all modes except OFF. The blower motor speed switch is an integral part of the HVAC module and cannot be installed separately.
The airflow mode setting determines air discharge location. Depressing each airflow mode selector button causes a corresponding movement of the airflow mode doors and determines the air discharge location. The airflow mode selector buttons are an integral part of the HVAC module and cannot be installed separately.
The A/C request button determines A/C compressor operation, except when the function selected is OFF, MAX or DEFROST. The A/C request button is an integral part of the HVAC module and cannot be installed separately.
The recirculated air request button can select recirculated air in any mode except DEFROST, and fresh air in any mode except MAX A/C or OFF.
The rear defog button signals activation of the heated backlight. The rear defog button is an integral part of the HVAC module and cannot be installed separately.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.