Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE BASE, 2D HATCHBACK, 2.5L ENG VIN X, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 1420 (MODULE COMMUNICATIONS NETWORK)
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Standard Trans
Section 1420 (Module Communications Network)
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Standard TransSECTION Section 1420 (Module Communications Network)
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Description And Operation
- Diagnostic Tests
- Communications Network
- Notes
- Principles of Operation
- Inspection and Verification
- DTC Tables
- Symptom Chart
- Pinpoint Tests
- Pinpoint Test A: The PCM Does Not Respond To The Scan Tool, or No High Speed Controller Area Network (HS-CAN) Communication
- Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool
- Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
- Pinpoint Test D: The Lighting Control Module (LCM) Does Not Respond To The Scan Tool
- Pinpoint Test E: The HVAC Module Does Not Respond To The Scan Tool
- Pinpoint Test F: The Vehicle Dynamics Module (VDM) Does Not Respond To The Scan Tool
- Pinpoint Test G: The Driver Door Module (DDM) Does Not Respond To The Scan Tool
- Pinpoint Test H: The Driver Seat Module (DSM) Does Not Respond To The Scan Tool
- Pinpoint Test I: The Rear Audio And Temperature Control (RATC) Module Does Not Respond To The Scan Tool
- Pinpoint Test J: The Liftgate/Trunk Module (LTM) Does Not Respond To The Scan Tool
- Pinpoint Test K: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool
- Pinpoint Test L: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
- Pinpoint Test M: Intermittent No High Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not Responding During The Network Test
- Pinpoint Test N: No International Standards Organization (ISO) 9141 Network Communications, All Modules Are Not Responding
- Pinpoint Test O: No Standard Corporate Protocol (SCP) Network Communication, All Modules Are Not Responding
- Pinpoint Test P: No Power To The Scan Tool
- Communications Network
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.