Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE BASE, 2D HATCHBACK, 2.5L ENG VIN X, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 156 (FUEL SYSTEM & ENGINE CONTROL SYSTEM)REMOVAL AND INSTALLATIONFUEL PUMP DRIVER MODULE (FPDM)REMOVAL AND INSTALLATION
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Automatic Trans
Removal and Installation
2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Automatic TransSECTION Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the rear seat cushion and the rear corner backrest. For additional information, refer to SEATING .
- Remove the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the fuel pump driver module (FPDM) electrical connector.
- Remove the 2 nuts and the FPDM.
- To install, tighten to 5 Nm (44 lb-in).
- To install reverse the removal procedure.
All vehicles
Five Hundred
Freestyle
All vehicles
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.