Inspection and Verification

2013 Volkswagen Beetle Base, 2D Hatchback, 2.5L Eng VIN X, Automatic TransSECTION Inspection and Verification
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

This part provides step-by-step module configuration procedures. Carry out the Programmable Module Installation  when another workshop article part directs to carry out configuration or when DTCs from the below list are present:

DTC CHART

DTC Description Source Action
B2477 Module Configuration Failure
  • ABS module
  • Instrument cluster (IC)
  • Parking aid module (PAM)
  • Restraints control module (RCM)
  • Vehicle security module (VSM)
CARRY OUT PMI. REFER to Programmable Module Installation .
B2900 VIN Mismatch
  • ABS module
REFER to VEHICLE DYNAMIC SYSTEMS article.
P0602 Powertrain Control Module Programming Error
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
P0605 Internal Control Module Read Only Memory (ROM) Error
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
P1639 Vehicle ID Block Corrupted, Not Programmed
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U0300 Internal Control Module Software Incompatibility
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2050 No Application Present
  • ABS module
  • IC
  • PCM
  • RCM
  • VSM
CARRY OUT PMI. REFER to Programmable Module Installation .
U2051 One or More Calibration Files Missing / Corrupt
  • ABS module
  • PCM
CARRY OUT PMI. REFER to Programmable Module Installation .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.