Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2013BEETLE (5C1) L5-2.5L (CBTA)REPAIR AND DIAGNOSISBODY AND FRAMEFRAMESUBFRAMEFRONT SUBFRAMESERVICE AND REPAIRTHREAD ON SUBFRAME MOUNTING, SERVICINGTHREAD INSERTS, INSERTING
2013 Volkswagen Beetle (5C1) L5-2.5L (CBTA)
Thread Inserts, Inserting
2013 Volkswagen Beetle (5C1) L5-2.5L (CBTA)SECTION Thread Inserts, Inserting
Thread Inserts, Inserting
- Turn the threaded insert - 3 - onto the spindle until the drive peg - 2 - makes contact on drive tab - 1 - of installing spindle.
• Thread insert must be able to be turned easily.
- Screw the threaded insert into the threaded plate until the threaded insert is seated flush with the outer edge of the threaded plate (check visually).
- Then tighten the threaded insert by a 1/4 turn further.
- Remove the spindle.
- Break off thread insert driver tang using tang breaker.
- Install the subframe (tightening specification). Refer to => Suspension, Wheels and Steering 40 Removal and Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.