Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012GOLF R 4MOTION (5K1) L4-2.0L TURBO (CRZA)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - LIGHTING AND HORNSHEADLAMP CONTROL MODULESERVICE AND REPAIRCORNERING LAMP AND HEADLAMP RANGE CONTROL MODULE (J745)
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)
Cornering Lamp and Headlamp Range Control Module (J745)
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)SECTION Cornering Lamp and Headlamp Range Control Module (J745)
Cornering Lamp and Headlamp Range Control Module (J745)
Removing
- Remove the glove compartment.
- Remove screws - arrows -.
- Remove the control module - 1 -. Pay attention to the wires still connected.
- Press the tab - arrow -, move the bracket - 1 - in - direction of arrow 2 - and disconnect the connector.
Installing
Install in reverse order of removal. Note the following:
• Code the new headlamp range/cornering lamp control module after installing it, refer to => [ Cornering Lamp and Headlamp Range Control Module (J745), Coding ] Testing and Inspection and then perform a basic setting on the headlamp.
- Check headlamp for function.
- Check the headlamp adjustment and adjust it if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.