Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012GOLF R 4MOTION (5K1) L4-2.0L TURBO (CRZA)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRDISPLAY AND CONTROL UNIT, ELECTRIC MANUAL
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)
Display and Control Unit, Electric Manual
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)SECTION Display and Control Unit, Electric Manual
Display and Control Unit, Electric Manual
• Perform the replace control module function, a basic setting and an adaptation "A/C compressor first start " either in Guided Fault Finding or in Guided Functions when installing a new A/C control module (J301).
•
Removing
- Remove the A/C and heater controls trim, (Golf 2009).
- Remove bolts- arrows - (1.5 Nm) and controls from the center console.
- Disconnect the connectors for the controls.
Installing
• Perform the replace control module function, a basic setting and an adaptation "A/C compressor first start " either in Guided Fault Finding or in Guided Functions when installing a new A/C control module (J301).
Installation is in reverse order of removal. Note the tightening specification 1.5 Nm for the screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.