Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012GOLF R 4MOTION (5K1) L4-2.0L TURBO (CRZA)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTSTEERING MOUNTED CONTROLS COMMUNICATION MODULESERVICE AND REPAIRSTEERING COLUMN SWITCH, WITHOUT KESSY, FROM 06.10STEERING COLUMN COMBINATION SWITCH (E595), VALEO
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)
Steering Column Combination Switch (E595), Valeo
2012 Volkswagen Golf R 4Motion (5K1) L4-2.0L Turbo (CRZA)SECTION Steering Column Combination Switch (E595), Valeo
Steering Column Combination Switch (E595), Valeo
Follow the specified sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.
Removal
- Remove the steering wheel.
- Remove the steering column trim.
- Remove Steering Column Electronic Systems Control Module (J527). Refer to => [ Steering Column Electronic Systems Control Module (J527) ] Steering Column Electronic Systems Control Module (J527).
- Unlock all 3 releases - arrows - and remove the entire steering column combination switch (E595) from the steering column switch base carrier.
Installation
- Push the steering column combination switch onto the guide on the steering column switch base carrier until it latches.
- Install all components in reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.