Steering Column Combination Switch (E595), through 10.09

Steering Column Combination Switch (E595), through 10.09

Removing and installing the steering column combination switch

Depending on equipment, the steering column combination switch consists of the following components and cannot be disassembled further in the event of repairs:

• Turn Signal Switch (E2)

• Headlamp Dimmer/Flasher Switch (E4)

• Cruise Control Switch (E45)

• Windshield Wiper Switch (E)

• Rear Window Wiper Switch (E34)

• Windshield Wiper/Washer Switch (E22)

• Windshield Wiper Intermittent Regulator (E38)

• Windshield and Headlamp Washer Pump Switch (E44)

Removing

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

Remove the following components in order:

• Danger of the airbag deploying!

• The airbag could deploy if the unit is mishandled.

• Follow all Safety Precautions when working on an airbag.

- Remove the steering wheel.

- Remove the steering column trim.

- Remove the steering column electronics control module (J527). Refer to => [ Steering Column Electronics Control Module J527, through 10.09 ] Steering Column Electronics Control Module J527, through 10.09.

- Remove Airbag Spiral Spring/Return Spring With Slip Ring (F138). Refer to => [ Airbag Spiral Spring/Return Spring With Slip Ring F138, through 10.09 ] Airbag Spiral Spring/Return Spring With Slip Ring F138, through 10.09.

- Remove segment sensor for steering column sensor. Refer to => [ Steering Angle Sensor G85, through 10.09 ] Steering Angle Sensor G85, through 10.09.

- Remove both bolts - arrows - on top side of Steering Column Combination Switch (E595).






- Pull off Steering Column Combination Switch (E595) toward rear from steering column.

Installing

Install in reverse order of removal.

- Tighten the threaded connections to the specification shown in => [ Steering Column Switch Module Overview, through 10.09 ] Steering Column Switch Module Overview, through 10.09.

• If the steering column combination switch malfunctions, the steering column electronic systems control module coding must be checked with output diagnostic test mode.