Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGRELAYS AND MODULES - STEERINGSTEERING COLUMN CONTROL MODULESERVICE AND REPAIRSTEERING COLUMN SWITCH MODULESTEERING COLUMN COMBINATION SWITCH (E595), FROM 10.09
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
Steering Column Combination Switch (E595), from 10.09
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Steering Column Combination Switch (E595), from 10.09
Steering Column Combination Switch (E595), from 10.09
Removing and installing the steering column combination switch
Depending on equipment, the Steering Column Combination Switch (E595) consists of the following components and cannot be disassembled:
• Turn Signal Switch (E2)
• Windshield Wiper Switch (E)
• Cruise Control Switch (E45)
The procedure for removing and installing the steering column combination switch differs depending on the manufacturer.
• Steering Column Combination Switch (E595).
• Steering Column Combination Switch (E595).
Manufactured by Valeo
Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module, from 10.09 ] Steering Column Switch Module, from 10.09.
Removing
- Remove the steering wheel.
- Remove the steering column trim.
- Remove the steering column electronics control module. Refer to => [ Steering Column Electronics Control Module J527, from 10.09 ] Steering Column Electronics Control Module J527, from 10.09.
- Unlock both releases - arrows - and remove the entire steering column combination switch from the steering column switch base carrier.
Installing
- Push the steering column combination switch onto the guide on the steering column switch base carrier until it latches.
- Install all components in reverse order of removal.
Manufactured by Kostal
Always follow the sequence when removing and installing steering column switch components. Refer to => [ Steering Column Switch Module, from 10.09 ] Steering Column Switch Module, from 10.09.
Removing
- Remove the steering wheel.
- Remove the steering column trim.
- Remove the steering column electronics control module. Refer to => [ Steering Column Electronics Control Module J527, from 10.09 ] Steering Column Electronics Control Module J527, from 10.09.
- Remove the bolt - arrow - and remove the entire steering column combination switch - 1 - from the steering column switch base carrier.
Installing
- Slide the steering column combination switch onto the guides on the steering column switch base carrier.
- Install the bolt - arrow -.
- Install all components in reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.