Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGPOWER STEERINGSTEERING CONTROL MODULELOCATIONS
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
Steering Control Module: Locations
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Locations
Control modules in engine compartment
Power steering control module -J500-
Component Location:
At steering on subframe, center -Arrow-
Pin Arrangements:
A - Power steering control module -J500-
Connector:
B - Not installed
C - 5-Pin Connector -T5z-
D - 2-pin connector -T2fn-
E - 3-pin connector -T3dt-
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.