Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLESYSTEM SPECIFICATIONS09M,09MA AUTOMATIC TRANSMISSION
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
09M,09MA Automatic Transmission
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION 09M,09MA Automatic Transmission
Fastener Tightening Specifications
• 1 Passat only
• 2 For bolt clarification, refer to => [ Transmission Fluid Cooler Overview ] Description and Operation.
• 3 Always replace
• 4 Install with a new seal
Transmission to Engine Bolt Tightening Specifications
1 - Driving Direction
- Drive Plate to Torque Converter
• 60 Nm
• Quantity 6
• Remove and install using the socket SW 15 (V/175)
- M12 Bolts
• 80 Nm
- M10 Bolts
• 40 Nm
• These bolts are located at the bottom of the flange.
Arrows - Alignment Sleeves
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.