Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSOLAR SENSORSERVICE AND REPAIR
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
Solar Sensor: Service and Repair
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Service and Repair
Sunlight Photo Sensor G107 or Sunlight Photo Sensor 2 G134
Special tools, testers and auxiliary items required
• Removal Wedge (3409)
Removing
- Mark dimensions "a and b" on the instrument panel with tape.
a = 115 mm
b = 15 mm
The indirect ventilation trim could get damaged.
The trim is mounted by a screw under the photo sensor.
Lift the trim maximum 15 mm.
- Using the (3409) unclip the right and left trim at the markings and remove them from the instrument panel.
- Insert a screwdriver - 3 - with a long blade toward the photosensor - 2 -.
- Use a block of wood - 1 - underneath.
- Push the screwdriver - in direction of arrow - and unclip the photosensor.
- Disconnect the connector from the sunlight photo sensor.
Installing
- Connect the connector to the photosensor and then install the photosensor in the instrument panel.
- Perform remaining installation operations in reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.