Display and Control Unit Overview

2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Display and Control Unit Overview






Display and Control Unit Overview, Passat from MY 06






1 Display Of Selected Interior Temperature, Left Side

2 Recirculating Air Mode Button

Press button for recirculating air function to prevent polluted air from entering interior.

3 Button - Center Air Distribution

4 Button - Lower Air Distribution

5 Button - Upper Air Distribution

6 Display Of Selected Interior Temperature, Right Side

7 Recirculating Air Mode Or Automatic Recirculating Air Mode Button

Press button for recirculating air function to prevent polluted air from entering interior.

Vehicles through 05.07. pressing the recirculation button again activates the automatic recirculation function.

Only for vehicles with an Air quality sensor (G238).

Air quality sensor function, refer to => [ Air Quality Sensor G238 Function ] Description and Operation.

8 Windshield Defroster Button

9 Push Button For Rear Window Defroster

10 Left Interior Temperature Knob

11 Blower Regulator

12 DUAL Button

For vehicles from calendar week 28 May 2007.

If the indicator light in the button comes on, different temperatures can be set for left and right.

When the Dual button is pressed (the indicator lamp turns off), then the temperature setting for the driver seat will also apply to the front passenger seat.

13 Interior Temperature Sensor

14 A/C ON/OFF Button or OFF Button

15 AUTO Button

By pressing the AUTO button, Climatronic maintains the selected vehicle interior temperature completely automatically. With this setting the vent air temperature, the blower speed and the air distribution are controlled automatically.

16 AC Button

Vehicle from 21 May 2007

Press the AC button to turn the A/C on or off.

When the light in the button is on, the air conditioner compressor is switched on.

17 ECON Button

Vehicles through 05.21.07:

Press the ECON button to turn the A/C on or off.

When the light in the button is on, the air conditioner compressor is switched on.

18 Right Side Interior Temperature Control

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.