Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSINFORMATION BUS
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
Information Bus
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Information Bus
Control modules in interior
Data Bus On Board Diagnostic Interface -J533-
Component Location:
Left-hand drive models:
In driver footwell near the pedal assembly -Arrow-
Right-hand drive models:
In the center console, below Radio/Navigation System
Pin Arrangements:
A - Data Bus On Board Diagnostic Interface -J533-
Connector:
B - 20-pin connector -T20e-
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.