Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2012CC 4MOTION (357) V6-3.6L (CNNA)REPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIRFENDER ASSEMBLY OVERVIEW
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)
Fender Assembly Overview
2012 Volkswagen CC 4Motion (357) V6-3.6L (CNNA)SECTION Fender Assembly Overview
Fender Assembly Overview
• The illustration shows the left side. The right side is identical.
1 Fender
• Removing and Installing, refer to => [ Fender ] Fender
2 Bolt
• 2 piece, at the A-pillar
• Quantity: 2, on sill panel
• Quantity: 3, on fender brace
• Quantity: 3, at fender connecting piece
• Tightening specification: 7.5 Nm
3 Fender end plate
4 Foam piece
• Inserted between fender and upper longitudinal member.
5 Fender brace
• Removing and Installing, refer to => [ Fender Brace ] Fender Brace
6 Bolt
• Quantity: 2
• Tightening specification: 2 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.