Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2010GOLF (5K1) L5-2.5L (CBTA)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDIAGRAMS
2010 Volkswagen Golf (5K1) L5-2.5L (CBTA)
Engine Control Module: Diagrams
2010 Volkswagen Golf (5K1) L5-2.5L (CBTA)SECTION Diagrams
Control modules in front part of vehicle
Engine Control Module (ECM) -J623-
Component Location:
Below the plenum chamber cover -Arrow-
154-pin, Pin Arrangements:
A - Engine Control Module (ECM) -J623-
Connector:
B - 94-pin connector -T94-
C - 60-pin connector -T60-
Note::
• -T154- consists of items B and C
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.