Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2010GOLF (5K1) L5-2.5L (CBTA)REPAIR AND DIAGNOSISBODY AND FRAMERELAYS AND MODULES - BODY AND FRAMEKEYLESS ENTRY MODULESERVICE AND REPAIR
2010 Volkswagen Golf (5K1) L5-2.5L (CBTA)
Keyless Entry Module: Service and Repair
2010 Volkswagen Golf (5K1) L5-2.5L (CBTA)SECTION Service and Repair
Access/Start Authorization Control Module (J518)
Code the "access/start authorization" system after replacing the access/start authorization control module. Refer to=> [ Access/Start Authorization Control Module (J518), Coding ] Access/Start Authorization Control Module (J518), Coding.
Removing
- Remove the footwell vent on the driver side.
- Open the retainers - arrow - and remove the access/start authorization control module - 2 - together with the mount - 3 - from the brake pedal bracket. Pay attention to the wires still connected.
- Disconnect the connector - 1 - and remove the access/start authorization control module - 2 - from its mount - 3 -.
Installation
Install in reverse order of removal, noting the following:
- Install the access/start authorization control module - 2 - in its mount - 3 -.
- Slide the bracket and control module onto the guide on the brake pedal bracket until it latches.
- Connect the connector - 1 -.
Code the "access/start authorization" system after replacing the access/start authorization control module. Refer to => [ Access/Start Authorization Control Module (J518), Coding ] Access/Start Authorization Control Module (J518), Coding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.