Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2008JETTA GLI (1K2) L4-2.0L TURBO (BPY)REPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMKEYLESS STARTING SYSTEMSERVICE AND REPAIRSTEERING COLUMN SWITCH, WITH KESSYSTEERING COLUMN SWITCH COMPONENTS, REMOVAL AND INSTALLATION SEQUENCE
2008 Volkswagen Jetta GLI (1K2) L4-2.0L Turbo (BPY)
Steering Column Switch Components, Removal and Installation Sequence
2008 Volkswagen Jetta GLI (1K2) L4-2.0L Turbo (BPY)SECTION Steering Column Switch Components, Removal and Installation Sequence
Steering Column Switch Components, Removal and Installation Sequence
When disconnecting and connecting the Battery, the procedure must be followed as described in the repair information. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
The shear bolts must be drilled out when removing the entire steering column switch including the steering column switch base carrier and the electronic steering column lock control module (J764). New shear bolts are needed when installing the electronic steering column lock control module.
Also, if only one individual component of steering column switch is removed or replaced, the sequence described in the following must always be adhered to.
• Risk of airbag deployment!
• The airbag could deploy if the airbag unit is handled incorrectly.
• Follow the safety precautions when working on the airbags.
Removal
- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
- Remove the steering wheel.
- Remove the steering column trim.
Remove the steering column switch components in the following sequence:
• Steering Column Electronic Systems Control Module (J527)
• Steering Column Combination Switch (E595)
• Electronic Steering Column Lock Control Module (J764)
• Base carrier for steering column switches
Installation
Installation is performed in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.