Diagram 87/8 (Tracks 85-98)

2008 Volkswagen Jetta GLI (1K2) L4-2.0L Turbo (BPY)SECTION Diagram 87/8 (Tracks 85-98)





IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


Vehicle Electrical System Control Module, Right/left LED Parking Lamp/DRL Module, Left/right Rear Turn Signal Lamps, Left/right Brake Lamps, Left/right Back-Up Lamps





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

J131 - Heated Driver Seat Control Module Component Locations Heated Driver Seat Control Module -J131-

J132 - Heated Front Passenger Seat Control Module Heated Front Passenger Seat Control Module -J132-

J519 - Vehicle Electrical System Control Module Component Locations Vehicle Electrical System Control Module -J519-

J774 - Front Heated Seats Control Module

L176 - Left LED Parking Lamp/DRL Module

L177 - Right LED Parking Lamp/DRL Module

M6 - Left Rear Turn Signal Lamp

M8 - Right Rear Turn Signal Lamp

M9 - Left Brake Lamp

M10 - Right Brake Lamp

M16 - Left Back-Up Lamp

M17 - Right Back-Up Lamp

T2 - Double Connector

T4a - 4-Pin Connector

T4b - 4-Pin Connector

T5a - 5-Pin Connector

T5c - 5-Pin Connector

T6 - 6-Pin Connector

T6g - 6-Pin Connector

T6f - 6-Pin Connector

T8v - 8-Pin Connector

T10a - 10-Pin Connector

T10b - 10-Pin Connector

(50) - Ground Connection (in luggage compartment, left)

(98) - Ground Connection (in rear lid wiring harness)

(369) - Ground Connection 4 (in main wiring harness)

(A84) - Connection (58L) (in Instrument panel wiring harness)

(A85) - Connection (58R) (in Instrument panel wiring harness)

(A87) - Back-up Lamp Connection (in instrument panel wiring harness)

(O12) - Connection 1 (in heated seat wiring harness)

(*) - Vehicles with heated seats only

(1)) - Through June 2007

(2)) - From July 2007

Previous Diagram 87/7 (Tracks 71-84)

Next Diagram 87/9 (Tracks 99-112)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.