Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2004JETTA SEDAN (9M2) L4-2.0L (AVH)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORSERVICE AND REPAIR
2004 Volkswagen Jetta Sedan (9M2) L4-2.0L (AVH)
Accelerator Pedal Position Sensor: Service and Repair
2004 Volkswagen Jetta Sedan (9M2) L4-2.0L (AVH)SECTION Service and Repair
Electronic Power Control (EPC) system
1. Mounting
2. Connector
^ - Black, 6-pin
3. 10 Nm
4. Throttle Position (TP) sensor -G79- and
^ Sender -2- for accelerator pedal position - G185
^ In vehicles with an automatic transmission kick down switch point must be learned again when sensor is replaced.
^ When removing remove cover under instrument panel
5. Bracket
^ For footwell cover
^ Clipped onto accelerator pedal
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.