Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN 4MOTION (3B3) W8-4.0L (BDP)REPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIR
2003 Volkswagen Passat Sedan 4Motion (3B3) W8-4.0L (BDP)
Fuse Block: Service and Repair
2003 Volkswagen Passat Sedan 4Motion (3B3) W8-4.0L (BDP)SECTION Service and Repair
Fuse Panel, Removing
- Remove drivers' side lower instrument panel trim.
- Carefully remove fuse panel cover at left side instrument panel.
- Remove screws -B-, 2 Nm (18 in lb), depress locking tabs -C- and remove fuse panel from the rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.