Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN 4MOTION (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESWITH GENERIC SCAN TOOLDIAGNOSTIC MODE 9: VEHICLE INFORMATION
2003 Volkswagen Passat Sedan 4Motion (3B3) V6-2.8L (ATQ)
Diagnostic Mode 9: Vehicle Information
2003 Volkswagen Passat Sedan 4Motion (3B3) V6-2.8L (ATQ)SECTION Diagnostic Mode 9: Vehicle Information
Diagnostic mode 9: Vehicle information
Function
In this diagnostic mode, vehicle specific diagnostic data such as e.g. the control module versions will be displayed.
Requirement
There must not be any DTCs stored in DTC memory, Diagnostic mode 3: Check DTC memory.
Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Switch ignition on.
- Under address word 33, select "Diagnostic mode 9: vehicle information".
- Select desired vehicle information "Test-ID XX".
Display vehicle information
- End diagnosis and switch ignition off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.