Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISTECHNICAL SERVICE BULLETINSRECALLSGENERALSCAMPAIGN - A/C PLENUM DRAIN MODIFICATIONCAMPAIGN WORK PROCEDURE
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)
Campaign Work Procedure
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION Campaign Work Procedure
Special Tools:
- Diagnostic Tool VAS 5051B or VAS 5052 Vehicle Diagnosis, Testing and Information Tool
- Diagonal Cutter (e.g. Snap-On # 388BCP) or equivalent
- VAG 1331 Torque wrench or (equivalent 5 - 50 Nm)
- 3409 Trim Removal Wedge tool, or equivalent
- Shop vacuum or air vacuum (e.g. Blue Point AV1000 or equivalent)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.