Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)
Ignition Switch: Service and Repair
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION Service and Repair
Ignition/Starter Switch, Removing And Installing
CAUTION!
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch the ignition off.
- Disconnect the battery Ground (GND) strap.
- After reconnecting battery, re-code and check operation of anti-theft radio.
Removing
- Remove upper and lower steering column switch trim. Removing steering column switches
- Disconnect electrical connector from ignition/starter switch .
- Remove locking paint from threaded holes of securing screws -A-.
- Loosen the two screws -A- slightly and pull ignition/starter switch out from steering lock housing in direction of arrow.
Installing
- Insert ignition/starter switch into steering lock housing.
NOTE: When installing the ignition/starter lock switch ensure that the ignition/starter lock switch and the lock cylinder are in the same position, e.g. "ignition on"
- Tighten screws and seal securing holes with locking paint.
- Reconnect multi-pin connector to ignition/starter switch .
- Reinstall steering column switches, trim and steering wheel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.