Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSFLYWHEEL
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)
Flywheel
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION Flywheel
Installing
- Fit drive plate with shim -1- and washer -2- onto crankshaft.
- Insert at least 3 old securing bolts and tighten to 30 Nm.
- Check dimension -a- at three points and calculate average.
Specification: approximately 12.3 mm
If the specifications are exceeded or not obtained:
- Remove drive plate again and fit appropriate shim -1-.
Note: Only one shim of the appropriate thickness may be used.
If the specification is attained:
- Insert new securing bolts and tighten by hand.
- Tighten securing bolts to 60 Nm and then turn 90° (1/4 turn) further (turning further can be done in several stages).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.