Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONMONITORS, TRIPS, DRIVE CYCLES AND READINESS CODESREADINESS CODE READINGWITH GENERIC SCAN TOOL
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)
With Generic Scan Tool
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION With Generic Scan Tool
Readiness code, reading
Requirements
- There must not be any DTCs stored in DTC memory, Diagnostic mode 3: Check DTC memory.
- Coolant temperature must be at least 80 degrees C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature. Diagnostic Mode 1: Check Measuring Values
Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 1: Checking measuring values."
- Select desired measuring value "PID 01".
- Observe the right 8-digit number block:
If all diagnoses have run through successfully, the 8-digit number block
Specified value: 00000000
must be displayed.
Evaluation PID 01: System status-information (right 8-digit number block:)
If a1 is displayed instead of a 0 in the 8-digit number block:
- Generate readiness code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.