Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2003PASSAT SEDAN (3B3) V6-2.8L (ATQ)REPAIR AND DIAGNOSISMAINTENANCETUNE-UP AND ENGINE PERFORMANCE CHECKSCOMPRESSION CHECKTESTING AND INSPECTIONCOMPRESSION PRESSURES, CHECKING
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)
Compression Pressures, Checking
2003 Volkswagen Passat Sedan (3B3) V6-2.8L (ATQ)SECTION Compression Pressures, Checking
Compression Pressures, Checking
Special tools and equipment
- 3122 B Spark plug spanner
- VAG 1331 Torque wrench (5-50 Nm)
- VAG 1763 Compression tester
Test conditions
- Engine oil temperature must be at least 30 C
Work sequence
- Remove engine cover.
- Disconnect spark plug connector and remove spark plugs with spark plug spanner 3122B.
- Pull 5 pin connector -1- off ignition coil final stage -2-.
- Remove fuse 28 (fuel pump) or pull connectors off all injectors.
- Have a second technician fully depress accelerator pedal.
- Check compression with compression tester VAG1381/VAG1763, operating starter until tester shows no further pressure increase.
Note: See relevant test unit operating instructions for instructions on how to use test unit.
Compression pressure:
- New: 9 - 14 bar
- Wear limit: 7.5 bar
Permissible difference between all cylinders: 3 bar
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.